|Projector type||1-Chip DLP™ projector|
|Panel size||16.8 mm (0.66 in) diagonal (16:9 aspect ratio)|
|Display method||DLP™ chip x 1, DLP™ projection system|
|Number of pixels||2716 x 1528 pixels (Images cannot be displayed at this resolution)|
|Light source||Laser diodes|
|Light output*1*2||10,000 lm|
|Time until light output declines to 50 %*3||20,000 hours (NORMAL/QUIET)/24,000 hours (ECO)|
|Resolution||4K (3840 x 2160 pixels) (With Smooth Pixel Drive)|
|Contrast ratio*1||10,000:1 (Full On/Full Off) (When [PICTURE MODE] is set to [DYNAMIC] and [DYNAMIC CONTRAST] is set to . HDMI signal input|
|Screen size (diagonal)||1.52–15.24 m (60–600 in) with ET-DLE060/ET-DLE088/ET-DLE158/ET-DLE178*4/ET-DLE258, 2.54–10.16 m (100–400 in) with ET-DLE020, 16:9 aspect ratio|
|Center-to-corner zone ratio*1||90 %|
|Lens||Powered zoom (throw ratio 1.60–2.58:1), powered focus (for supplied lens; optional lenses also available)|
|Lens shift(From the origin point of the lens mounter)|
|Vertical||±60 % with ET-DLE088/ET-DLE158/ET-DLE178*4/ET-DLE258 (+59 %, -40 % with ET-DLE020, ±49 % with ET-DLE060) (powered)|
|Horizontal||±25 % with ET-DLE088/ET-DLE158/ET-DLE178*4/ET-DLE258 (±24 % with ET-DLE020, ±19 % with ET-DLE060) (powered)|
|Keystone correction range||TBD|
|Installation||Ceiling/floor, front/rear, free 360-degree installation|
|HDMI IN||HDMI 19-pin x 2 (Compatible with HDCP 2.3, Deep Color, 4K/60p signal input)|
|MULTI SYNC IN||BNC x 1|
|MULTI SYNC OUT||BNC x 1|
|SERIAL IN||D-sub 9-pin (female) x 1 for external control (RS-232C compliant)|
|SERIAL OUT||D-sub 9-pin (male) x 1 for link control (RS-232C compliant)|
|REMOTE 1 IN||M3 stereo mini-jack x 1 for wired remote control|
|REMOTE 1 OUT||M3 stereo mini-jack x 1 for link control (for wired remote control)|
|REMOTE 2 IN||D-sub 9-pin (female) x 1 for external control (parallel)|
|DIGITAL LINK/LAN||RJ-45 x 1 for network and DIGITAL LINK connection (video/network/serial control) (HDBaseT™ compliant), 100Base-TX (Compatible with PJLink™ [Class 2], Art-Net, HDCP 2.3, Deep Color, 4K/60p signal input)|
|LAN||RJ-45 x 1 for network connection, 10Base-T, 100Base-TX (Compatible with PJLink™ [Class 2], Art-Net)|
|USB||USB Connector (Type A) x 1 for Cloning/Wireless Module (Output 5 V/500 mA)|
|DC OUT||USB Connector (Type A) x 1 (Output 5 V/2 A)|
|Expansion Slot||Open slot for SLOT NX compatible interface board|
|Power supply||AC 100–240 V, 50/60 Hz|
|Cabinet materials||Molded plastic|
|Operation noise*1||39 dB (NORMAL/ECO) [TBD] / 35 dB (QUIET) [TBD]|
|Dimensions(W x H x D)*5||498 x 200 x 538 mm (19 19/32˝ x 7 7/8˝ x 21 3/16˝ ) excluding lens [TBD]|
|Weight*6||Less than 25 kg (55.1 lbs) excluding lens [TBD]|
|Operating environment||Operating temperature: 0–45 °C (32–113 °F)*7*8, operating humidity: 10–80 % (no condensation)|
|Applicable software||Logo Transfer Software, Multi Monitoring & Control Software, Early Warning Software, Geometry Manager Pro, Smart Projector Control for iOS/Android™|
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118: 2020 international standards. Value is average of all products when shipped.
*2 When [PICTURE MODE] is set to [DYNAMIC] and [LIGHT POWER] is set to [NORMAL].
*3 Around this time, light output will have decreased to approximately 50 % of its original level ([PICTURE MODE]: [DYNAMIC], [DYNAMIC CONTRAST] set to , temperature 35 °C (86 °F), elevation 700 m (2,297 ft) with 0.15 mg/m3 of particulate matter). Estimated time until light output declines to 50 % varies depending on environment.
*4 ET-DLE178 is equivalent of supplied lens. Availability of ET-DLE178 varies depending on country.
*5 With legs fully retracted, excluding lens and protruding parts.
*6 Average value. May differ depending on the actual unit.
*7 When using the projector at an altitude lower than 2,700 m (8,858 ft) above sea level, and the operating environment temperature becomes 30 °C (86 °F) or higher, the light output may be reduced to protect the projector. When using the projector at an altitude between 2,700 m (8,858 ft) and 4,200 m (13,780 ft), and the operating environment temperature becomes 25 °C (77 °F) or higher, the light output may be reduced to protect the projector.
*8 When optional AJ-WM50 Series wireless module is attached, operating temperature range becomes 0–40 °C (32–104 °F).
如有投影機、投影布幕以及其他周邊商品相關需求，歡迎您填寫以下表單與我們聯絡( 服務時間: 平日 9:00~18:00 )，亦可來電：
※ 客服服務時間 : 週一至週五 9:00~18:00